[BusyBox] Help - how to start a script after busybox finish initialization?

[Lee Xing]

Hi,

I'm using a HardHat Linux 20 (kernel 2.4.2_hhl20), and have a question on how to start a script ** after ** busybox is loaded.  I would appreciate it if someone could help.

Attached is the capture after reboot on the target embedded system.  The last steps seem to me are loading the busybox.  My question is how I can start/run a script (to load a couple of modules) after the last step in the following trace.

Thank you.


Lee


...
...

Starting kswapd v1.8
pty: 256 Unix98 ptys configured
block: queued sectors max/low 18600kB/6200kB, 64 slots per queue
RAMDISK driver initialized: 16 RAM disks of 6144K size 1024 blocksize
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 4194303k freed
Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI ena
bled
ttyS00 at 0x1c800000 (irq = 5) is a 16550
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 2048)
IP-Config: No network devices available.
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
Freeing unused kernel memory: 64k freed
serial console detected.  Disabling virtual terminals.
init started:  BusyBox v0.60.0 (2001.08.24-22:09+0000) multi-call binary

BusyBox v0.60.0 (2001.08.24-22:09+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

#
#
#